You will need these tools & supplies to follow the 20D infrared conversion tutorial:

- Our custom glass infrared filter to replace the hotmirror
- Soldering iron and desoldering wick or desoldering gun
- Black silicone adhesive /w syringe type dispenser
- Small philips type screwdriver
- Tweezers
- Canned air
- Lens cleaning solution & tissue
- Grounding strap /w current limit resistor

If you prefer not to risk damage to your camera, have us convert it to infrared for you. It would be best to perform the conversion in a well lit area that is as clean and dust free as possible. Wearing a grounding strap will minimize the chance of zapping your camera with static and most likely rendering it dead.

Remove the rubber grip material.

Remove the rubber eye cup and marked screws

Remove marked screws.

Remove marked screws.

Gently lift up and flip over the rear LCD display panel and disconnect the marked ribbon cable.

The connectors are flip type unless indicated otherwise, just flip up the brown/gray lever to release the ribbon cable.

Remove the I/O cover.

Peel off and fold over the marked copper noise shields.

Remove marked screws.

Disconnect the marked ribbon cable.

Fold over the marked ribbon cable so it’s out of the way of the soldering iron.

Desolder the marked solder joint.

Disconnect the marked cables. Pull to disconnect the connector marked with the blue arrow.

Lift out the LCD display assembly and remove the indicated adhesive tape.

Desolder the marked solder joints and lift out the noise shield.

Disconnect the marked cables and remove the screw marked with the blue arrow.

A closeup view – to disconnect just pull out the blue lever (shown in open position).

Gently lift up and fold over the PCB and remove the marked screws.

Remove the marked screws.

Remove the hot mirror assembly by gently prying up to release from adhesive gasket.

Remove the hot mirror assembly and set the sensor aside.

Peel off the adhesive gasket from the hot mirror – be careful not to tear it.

Remove the black hot mirror mask.

Gently cut the adhesive around the hot mirror filter and remove the hot mirror.

The following image is a comparison between the original hot mirror filter (on left)
and the our replacement IR filter (on right).

Glue all around the infrared filter to seal from dust particles and affix the filter in position.

The infrared filter after silicone sealant is applied.

After adhesive is fully cured clean the ir filter with lens cleaner and tissue, blow off with canned air and reassemble everything by following the instructions backwards. Set a custom white balance per our instructions page and take some test shots to make sure there is no dust trapped between the sensor and infrared filter. If you find dust and find it objectionable disassemble the camera again, blow off the sensor with canned air (make sure only air and no liquid is coming out by purging and holding it upright) and re cleaning the infrared filter.

If you prefer not to risk damage to your camera, have us convert it for you here.